ANFIM Luna Troubleshooting

troubleshooting: Anfim Luna
fault cause
The grinder
The mains plug is not
is not grind-
plugged in.
ing, the
The bean hopper has not
display is
been inserted.
not lit up.
The overcurrent protection
switch has been triggered.
The electrical fuse has
tripped.
The grinder
The grinding mechanism
is making
is clogged. / The grinding
noise but not
degree is too fine.
grinding.
Ground coffee has built up in
the grinder because of an
excessive amount of coffee.
A foreign object has got into
the grinding mechanism.
Remedy
» Insert the power plug into a properly
installed socket.
»
Insert the bean hopper (see Instruction
manual „Inserting the bean hopper").
» Check whether the release button of
the circuit breaker has popped out.
Push it back in if necessary. If the
button circuit breaker continues to
pop out, contact a service technician
for support.
» Check the electrical fuse. If required,
restore the fuse to its original state or
replace it. Check whether other loads are
connected to this fuse and if so, pull out
their plugs. If the fuse repeated trips,
contact a service technician for support.
» Set the grinder to the highest (coarsest)
setting and start the grinding process.
The grinder will clear itself. Then set the
desired grinding degree during
operation again.
» With the grinder switched off, clean the
spout including the spring using a
brush. Set the grinder to the highest
(coarsest) setting and start the grind-
ing process. The grinder will clear itself.
Then set the desired grinding degree
during operation again.
» Clean the grinder (see Anfim Luna Service
YouTube playlist: "Grinder Cleaning" /
"Burr Replacement" videos) and remove
the foreign object. If the foreign body
cannot be removed in this way, contact a
service technician for support.
luna | En