Trouble-Shooting Guide - NEFF B1451B2GB How To Connect

Calling the customer service is not always really necessary. In some cases, you can remedy the situation your-
self. The following table may contain some helpful tips.
Important general safety guidelines:
Service or repair work on the electronic components may only be performed by a qualified expert. Without exception, prior
to starting such repairs, the appliance must be disconnected from the mains. This may be accomplished by tripping the
automatic fuse or by removing the fuse from the fuse box that controls your flat or apartment.
Problem
There is a general failure of all electri-
cal functions, i.e., the control lamps
have suddenly ceased to function.
Liquids or thin cake mixes are distri-
buted at a visibly uneven thickness.
The electronic timer display sudden-
ly shows a blinking 0.00.
The oven suddenly stop functioning.
... if electronically controlled func-
tions fail?
... if enamelled slide-in parts have
dull, light blotches?
... if the hydroclean system control
lamp fails to illuminate after the func-
tion has been activated?
... if after prolonged use, the oven
window panes are soiled from the
inside.

Trouble-shooting Guide

Possible cause
Defective fuse.
The appliance has not been placed
or installed plumb-and-level.
The power supply was briefly inter-
rupted.
The electronic timer is set to an auto-
matic timing cycle.
Energy pulses (e.g. lightning flash).
Normal occurrence due to dripping
meat juices.
Temperature inside oven cavity is still
too high.
Defective control lamp.
This kind of soiling is normal.
Remedy
Check the fuse in the fuse box, and
replace if required.
Level the appliance using the level-
ling feet, or check the installation.
Reset the time of day.
Set electronic timer to operation
without automatic timer:
1. Reset ON time g to {:{{.
2. Press the g button.
Reset the relevant functions.
Not possible.
Prior to using the
system, the oven must be allowed to
cool completely.
Replacement only by an authorised
expert.
Remove the oven door and lay
front side down on a soft, clean
base.
Grip the door glass near the hinges,
pull up and remove.
Doors with 3 panels:
Disengage inner door glass at the
corner pieces and lift it up using, for
example, a pair of frying tongs made
of plastic or wood.
Installing the cleaned glass:
Insert the inner door glass and lock
into position.
Attach the door glass and lock into
position by pressing the glass near
the hinges.
hydroclean
21