Omron WS02-NSFC1-EV3 - 12-2007 Operation Manual page 81

Segment Program 2 (Block Model 157)
66
16: STEP Numeral Display
A Numeral Display and Input object is used to display the value for tag ITEM
Y3 (ITEM 011: Step output). A Control Flag is set to disable input.
Tag ITEM Y3 (ITEM 011) uses values 1 to 30 from the PLC device/communi-
cations, but the PLC or communications values are displayed with 2 integer
digits and 0 digits below the decimal point, without scaling the values on the
display.
Other Settings
Segment Program 2 does not provide an MV display, MV index position, SP
Change Button, or MV Change Button.
The following diagram shows the face plate for Segment Program 2 built with
the Face Plate Auto-Builder for NS in a 640×480 screen resolution. The whole
face is built using 458×142 dots.
The display and operation of each object in the face plate is the same as the
version for 800×600 screen resolution.
Section 6-7