OneOdio OpenRock Pro User Manual page 7

UK Declaration of Conformity
Hereby, YI ZHAO (SHENZHEN) CO., LIMITED declares that the product type Y80B is in
compliance with following Directives: Radio Equipment Regulations 2017, Electrical Equipment
(Safety) Regulations 2016 and The Restriction of the Use of Certain Hazardous Substances in
Electrical and Electronic Equipment Regulations 2012. The full text of the UK declaration of
conformity is available at the following internet address:www.oneodio.com info@oneodio.com
1. Use careful with the earphone maybe possible excessive sound pressure from
earphones and headphones can cause hearing loss.
2. Caution: risk of explosion if battery is replaced by an incorrect type. Dispose
of used batteries according to the instructions.
3. The device complies with RF specifications when the device used at 0mm
form your body.
Manufacturer's Name: YI ZHAO (SHENZHEN) CO., LIMITED
Product: Wireless headphone
Model number: OpenRock Pro
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:(1) This device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance
could void the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
- Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device can be
used in portable exposure condition without restriction.