EN
IMPORTANT SAFETY INSTRUCTIONS
Please read and keep all safety and use instructions.
WARNINGS/CAUTIONS
Do NOT use the headphones at a high volume for any extended period.
– To avoid hearing damage, use your headphones at a comfortable, moderate
volume level.
– Turn the volume down on your device before placing the headphones in/on
your ears, then turn the volume up gradually until you reach a comfortable
listening level.
Do NOT use your headphones while driving for phone calls or any other purpose.
Do NOT use the headphones at any time the inability to hear surrounding sounds may present a
danger to yourself or others, e.g., while riding a bicycle or walking in or near traffic, a
construction site or railroad, etc.
– Remove the headphones, to ensure you can hear surrounding sounds,
including alarms and warning signals.
– Be aware of how sounds that you rely on as reminders or warnings may
vary in character when using the headphones.
Do NOT use the headphones if they emit any loud unusual noise. If this happens, turn the
headphones off and contact OneOdio customer service.
Remove headphones immediately if you experience a warming sensation or loss of audio.
Do NOT use mobile phone adapters to connect headphones to airplane seat jacks, as this could
result in injury or property damage due to overheating.
Do NOT use the headphones as aviation communication headsets except in case of emergency.
– No incoming audio will be heard with a discharged or improperly installed battery.This could
result in the potential of missed communications while piloting an aircraft.
– Extremely loud ambient noise levels commonto many propeller-driven aircraft may impair
your ability to receive incoming audio communications, particularly during takeoff and climb out.
– The headphones are not engineered for noise conditions, altitude, temperature or other
environmental conditions common in non-commercial aircraft, resulting in possible interference
to critical communications.
Need help?
Do you have a question about the OpenRock Pro and is the answer not in the manual?