Omron SYSDRIVE 3G3JV Setup Manual page 11

Warnings for UL/cUL Marking
• Do not connect or disconnect wiring, or perform signal checks while the power supply is turned ON.
• The Inverter internal capacitor is still charged even after the power supply is turned OFF. To prevent
electrical shock, disconnect all power before servicing the Inverter. Then wait at least one minute after
the power supply is disconnected and all indicators are OFF.
• Do not perform a withstand voltage test on any part of the Inverter. This electronic equipment uses
semiconductors and is vulnerable to high voltage.
• Do not remove the Digital Operator or the blank cover unless the power supply is turned OFF. Never
touch the printed control board (PCB) while the power supply is turned ON.
• The Inverter is not suitable for use on a circuit capable of delivering more than 5,000 RMS symmetrical
amperes, 250 volts maximum (100-V-class Units).
• Take measures against overcurrent, overload, and overheating by using the Motor Protection Set-
tings.
Use 75°C copper wires or equivalent.
Low voltage wires shall be wired with Class I Wiring.
H Motor Protection Settings
Rated Motor Current (n32)
• Set the rated motor current (n32) in order to prevent the motor from burning due to overloading.
• Check the rated current on the motor nameplate and set the parameter.
• This parameter is used for the electronic thermal function for motor overload detection (OL1). By set-
ting the correct parameter, the overloaded motor will be protected from burning.
n32 Rated Motor Current
Setting 0.0% to 120% (A) of rated
range output current of Inverter
Note 1. The standard rated current of the maximum applicable motor is the default rated motor cur-
rent.
Note 2. Motor overload detection (OL1) is disabled by setting the parameter to 0.0.
Motor Protection Characteristics (n33 and n34)
• This parameters setting is for motor overload detection (OL1).
n33 Motor Protection Characteristic Selection
Setting 0 to 2
range
D Set Values
Value
0 Protection characteristics for general-purpose induction motors
1 Protection characteristics for Inverter-dedicated motors
2 No protection
CAUTION
Unit of 0.1 A
setting
Unit of 1
setting
Description
Changes during No
operation
Default setting (see note 1)
Changes during No
operation
Default setting 0