Download Print this page

Maintenance; Floor Nozzle; Checking For Blockages - Shark VERTEX MultiFLEX DuoClean PowerFins IZ440 Series Owner's Manual

Cordless vacuum with self-cleaning brushroll

Advertisement

MAINTENANCE

FLOOR NOZZLE

FLOOR NOZZLE
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface,
a low-pile carpet, or a small area rug. If some fibers remain wrapped around the brushroll after continued use,
carefully remove them. If you run over a hard or sharp object, notice a noise change while vacuuming, or the
nozzle indicator light turns red, check for blockages or objects caught in the self-cleaning brushroll or Soft Roller.
1. Turn off the vacuum.
2. Using a coin, turn locks counterclockwise to open, then lift off cover to access the self-cleaning
brushroll.
3. Clear airway of blockages.
4. Replace cover by sliding inserts into slots, then pressing down firmly on all sides before turning locks
clockwise to close, until they click securely into place.
5. If light on floor nozzle is red, see Troubleshooting section for resolution.
CLEANING SOFT ROLLER
s h a r kc l e a n . c o m
1
To remove the Soft Roller from the nozzle, pull it out
by the tab.
2
Tap loose debris off the Soft Roller. Use a dry towel to wipe
the Soft Roller clean, and to remove any debris caught in the
teeth behind the Soft Roller.
3
Hand wash the Soft Roller as needed. Use only water, and let
air-dry completely for at least 24 hours.
4
Reinstall the Soft Roller in the nozzle.
MAINTAINING YOUR VACUUM

CHECKING FOR BLOCKAGES

Checking for Blockages in the Handheld Vacuum:
1. Turn off vacuum.
2. Remove the handheld vacuum from the wand.
3. Check all intake openings to the dust cup and remove any
debris or blockage.
Checking for Blockages in the Wand:
Standard Wand:
1. Turn off vacuum.
2. Remove the handheld
vacuum and floor nozzle.
3. Check intake openings for
blockages and debris.
4. Clear away debris and
blockages.
Checking for Blockages in the Floor Nozzle:
1. Turn off vacuum.
2. Detach the wand.
3. Use the edge of a coin to open the three locks on the
bottom of the floor nozzle.
4. Remove the cover and tilt back the neck of the floor
nozzle.
5. Check the opening and remove any debris.
6. Replace the cover by sliding the inserts into the slots, then
pressing down firmly on all sides before turning the locks
clockwise to close, until they click securely into place.
MultiFLEX® Wand:
1. Turn off vacuum.
2. Remove the handheld
vacuum and floor nozzle
from the wand.
3. Check the Clog Access
Hose on the MultiFLEX
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out.
4. Clear any debris and
blockages.
sharkclean.com

Advertisement

loading
Need help?

Need help?

Do you have a question about the VERTEX MultiFLEX DuoClean PowerFins IZ440 Series and is the answer not in the manual?

Subscribe to Our Youtube Channel