Advertisement
Advertisement
Table of Contents
Related Manuals for Shark V2945Z
Summary of Contents for Shark V2945Z
- Page 1 V2945Z OWNER’S GUIDE www.sharkclean.com...
-
Page 2: Important Safety Instructions
CORDLESS FLOOR AND CARPET SWEEPER. with brush roll blocked; keep free of fiber, lint, hair ® and anything that may prevent the brush roll from WHEN USING YOUR SHARK CORDLESS FLOOR AND working. CARPET SWEEPER, BASIC SAFETY PRECAUTIONS SHOULD ALWAYS BE OBSERVED, INCLUDING THE... - Page 3 TO MAXIMIZE THE LIFE OF YOUR Warning: Changes or modifications to this unit NI-MH BATTERIES: not expressly approved by the party responsible for Charge for 7 hours before initial use. Failure compliance could void the user’s authority to operate to do so will reduce the product’s battery life the equipment.
-
Page 4: Quick Start
2 Pull back on the handle and right with your foot to change poles into the elbow joint to press lightly on the body of the the speeds. One light indicates form the Shark Backsaver unit with your foot to engage the ® ™... - Page 5 Fig. 4 Fig. 6 Fig. 5 EMPTY 5 The Shark Backsaver folding 7 Empty dust container contents. ® ™ 6 When you’re finished cleaning, handle makes cleaning under (Fig. 6) If desired, you may pull the dust container straight furniture a breeze. Just press rinse with water to clean out from the side.
- Page 6 Fig. 2 Fig. 1 COMPONENTS: ASSEMBLY OF YOUR FLOOR AND CARPET SWEEPER: A Main Unit NOTE: The charging adapter 2 Insert the Shark Backsaver ® ™ B Speed Control Button and lower handle will be folding handle you just C Power Button shipped inside the packaging.
- Page 7 CHARGING YOUR CORDLESS FLOOR AND CARPET SWEEPER Fig. 4 Fig. 3 1 Always make sure that the unit 3 Charge the battery for 7 hours IMPORTANT: Although many is turned off. (Fig. 3) before initial use and 7 hours adaptors look similar, it’s for each recharge.
-
Page 8: Emptying The Dust Container
Press the handle Do not use the unit to clean release button and apply a bit tasseled or frayed carpets. of pressure to bend the handle forward. (Fig. 7) The Shark ® Backsaver joint will release ™ from the locked position to Fig. -
Page 9: Maintenance
MAINTENANCE Fig. 12 Fig. 14 Fig. 15 Fig. 13 Fig. 16 5 Carefully lift and remove the 5 Connect the wire terminal from CAUTION: Do not clean the unit brushbar from the belt. the unit to the wire terminal while it is charging. (Fig. -
Page 10: Troubleshooting Guide
TROUBLESHOOTING GUIDE PROBLEM POSSIBLE REASONS AND SUGGESTED SOLUTION The unit will not operate Batteries need to be recharged. Batteries are dead and need to be replaced. There is no power in the electrical outlet supplying the charging adapter. Try to charge using a different outlet. Ensure the wire terminal connectors on the battery pack are securely attached. -
Page 11: Warranty And Product Registration
Mark the outside of your package “ATTENTION CUSTOMER SERVICE”. We are constantly striving to improve our products, therefore the specifications contained herein are subject to change without notice. PRODUCT REGISTRATION Please visit www.sharkclean.com or call 1-800-798-7398 to register your new Shark product within ten (10) ®... - Page 12 Copyright © 2013 Euro-Pro Operating LLC USA: Newton, MA 02459 CANADA: Ville St-Laurent, QC H4S 1A7 Printed in China Illustrations may differ from actual product. Euro-Pro and Shark, are trademarks of Euro-Pro Operating LLC. V2945Z.E.131115.8 www.sharkclean.com 1-800-798-7398...
Need help?
Do you have a question about the V2945Z and is the answer not in the manual?
Questions and answers