Omron NS-CXDC1-V3 - 12-2009 User Manual page 36

Installing the CX-Designer
Installation Procedure
1,2,3...
14
1. Start up Windows.
2. Close all applications before executing installation. Place the CX-Designer
CD-ROM in the CD-ROM drive. The setup program is started automatical-
ly. If the setup program does not start automatically, such as after execut-
ing uninstall, locate Setup.exe in the CD-ROM using Windows Explorer,
and then double-click the file to execute the setup program.
Note If CX-Designer is already installed, a dialog box to confirm deletion of this ver-
sion will be displayed. Click the OK Button to start deleting this version. To exit
the setup program, click the Cancel Button and then click the Exit Button. Fin-
sGateway and CX-Server will not be uninstalled by this operation.
3. The CX-Designer Setup Wizard will be displayed.
Install the CX-Designer by following the instructions in the Setup Wizard.
4. During installation, the installation progress is displayed as a percentage.
5. When CX-Designer installation has been completed, a message to confirm
installation of Smart Active Parts will be displayed. Click the Yes Button to
start the installation. If Smart Active Parts installation is not required, click
the No Button and proceed to step 10.
Smart Active Parts are libraries containing setting/monitoring screens
(e.g., Position Control Unit setting screens and Temperature Controller
monitoring screens).
Section 2-2