Step 2
Teaching
Teaching means to store the region and the edge width in the region as reference data for the measurement.
[Inspect] − [Add item.] − [Edge Width] − [Settings] Tab Page
1
Press [Teach].
2
Place the object that is to be used as the measure-
ment reference in front of the camera.
3
Move the rectangle to the location to be measured.
4
Press [OK].
5
Press [TEACH] on the lower right of the display.
The basic settings will be registered when teaching has
been completed.
6
Press [Back] to end teaching.
The following data is stored as the measurement reference.
Item
Parameter
Reference data
Reference width
Step 3
Adjusting the Judgement Parameters
[Inspect] − [Add item.] − [Edge Width] − [Settings] Tab Page
1
Press [Judgement].
2
Set the D. Width range for an OK judgement.
Continuous measurements will be performed for the im-
ages that are displayed.
3
Press [OK] to enter the value.
Item
Parameter
Judgement Parameter
D. Width
FQ Short Manual
The middle arrow is the direction for
detecting an edge.
Moves the
starting
point of the
measure-
ment
region.
Description
The reference edge width is set automatically.
Lower limit
Blue for OK. Red for NG.
Setting
Range: −893 to 893
Default: Lower limit: −893, Upper
limit: 893
Inspecting with the Edge Width Inspection Item
Moves the
Drag to
Changes the
end point of
move the
width of the
the
region.
measure-
measure-
ment region.
ment region.
Upper limit
Description
Set the upper and lower limits of the
reference width for an OK judgement.
41