KWIK GOAL 2J102 Assembly Instructions page 5

10. After concrete has cured remove goal and attach uprights to goal. NOTE: countersunk holes in uprights
indicate front face of uprights. (This side must face playing field.)
Countersunk Hole
Upright
1/2" Lock Nut
1/2" Flat Head Screw
11. When removing goal from field after initial installation, the crossbar can be removed before removing goal
posts from ground sleeves. Do this by removing the two 1/2" flat head screws and then sliding crossbar to
one side. Be sure to cover open ground sleeves with caps to stop debris from entering hole after removing
goal posts.
12. After reinstallation be sure to re-seal seam between ground sleeve and goal posts to stop debris from
entering ground sleeves.
This goal has been designed to be used for the game of rugby only. Goal posts must be anchored
AT ALL TIMES and shall be secured against overturning. Do not climb on the goal framework at
anytime! All fastenings must be checked to insure they are fully tightened before and after each
use of this product. Goal posts not in use must be disassembled and properly stored in a safe,
secure area. Assembled goal posts should not be left unattended. Do not use this equipment
during the threat of high winds. Goal posts should be checked for safety before and after each
use. All warning and safety labels included with this product must be visible at all times. Any
modifications to this or any Kwik Goal product will void any and all warranties.
Go to kwikgoal.com for additional product information.
***CAUTION***
NZ343 Rev. 07/17/17