KWIK GOAL 2J102 Assembly Instructions

1. Unpack all parts and check for damage that may have occurred during shipping. If damage has occurred,
notify trucking company immediately. Lay out all parts. Remove all cardboard and packaging immediately.
Wet or damp packaging may damage contents.
2. Read through entire instruction before beginning assembly and installation.
3. This equipment should be installed by a minimum of three experienced installers.
4. WARNING: Do not attempt to assemble or disassemble crossbar and/or uprights in winds greater than 5MPH.
Parts
Upright (2)
(Part# UZ1361) - 306" overall length
Crossbar (1)
(Part# UZ1362) - 208" overall length
This goal has been designed to be used for the game of rugby only. Goal posts must be anchored
AT ALL TIMES and shall be secured against overturning. Do not climb on the goal framework at
anytime! All fastenings must be checked to insure they are fully tightened before and after each
use of this product. Goal posts not in use must be disassembled and properly stored in a safe,
secure area. Assembled goal posts should not be left unattended. Do not use this equipment
during the threat of high winds. Goal posts should be checked for safety before and after each
use. All warning and safety labels included with this product must be visible at all times. Any
modifications to this or any Kwik Goal product will void any and all warranties.
ASSEMBLY INSTRUCTIONS FOR 2J102 RUGBY GOAL
140 Pacific Drive Quakertown, PA 18951
(P) 215-536-2200 / (P) 800-531-4252 / (F) 215-536-4309 / (F) 800-778-8869
Visit our website @ kwikgoal.com
2
Post (2)
(Part# UZ1363)
***CAUTION***
012, Rev 2017 Kwik Goal Ltd.
Ground Sleeve Cap (2)
(Part# UZ56)
Ground Sleeve (2)
(Part# UZ675)
NZ343 Rev. 07/17/17