Omron DYALOX INDUSTRIAL PC Quick Start Manual page 23

Monitoring
Function Item
All On/Off
Monitoring
Startup
timer
On error...
Try to reset
Monitoring
Alive
Cycle
On error...
Monitoring
Shutdown
timer
On error...
Note: The Startup Monitoring is active even during the BIOS setup! Therefore, disable the
Startup Monitoring to configure the BIOS settings. With Dip Switch pin no. 8 on the RAS
Board you can disable RAS monitoring functions.
Logging Cycle
Here you configure the logging cycle of the RAS board.
Item Description
On/Off Enables/disables the RAS logging.
starts Specifies a time after the IPC startup for the Initial logging.
at intervals of Specifies intervals for the periodic logging.
LCD Setting
Item Description
ON/Off Enables/disables the LCD Backlight monitoring.
LCD Backlight Selects a level of the LCD backlight brightness among from High, Middle
Brightness and Low. Default is High.
Note: For NSA-CPU0x-E models the LCD Backlight monitoring is not supported.
Description
Enables/disables the function.
Specifies a monitoring time for startup.
If the startup process was not completed within the specified
period, the RAS Board detected a Startup failure.
No No action when a Startup failure occurs.
Action
Reset The RAS Board forces the Motherboard to reset on a
Startup failure.
If the next startup process was not completed within the
specified period again, the trial repeats up to a specified
number of times in [Try to restart].
Power The RAS Board forces the Motherboard to Power Off
OFF when a Startup failure occurs.
Specifies a number of times to repeat the restart cycle.
Specifies monitoring intervals for the Alive check.
If the RAS service does not respond within the specified period,
the RAS Board detected an Alive Failure.
No No action when the Alive failure occurs.
Action
Reset The RAS Board forces the Motherboard to reset when
an Alive failure occurs.
Power The RAS Board forces the Motherboard to Power Off
OFF when an Alive failure occurs.
Specifies a monitoring time for Shutdown.
If the shutdown process was not completed within the specified
period, the RAS Board detected a Shutdown Failure.
No No action when the Shutdown failure occurs.
Action
Reset The RAS Board forces the Motherboard to reset when a
Shutdown failure occurs.
Power The RAS Board forces the Motherboard to Power Off
OFF when a Shutdown Failure occurs.
!
19