1. Safety instructions • This device is suitable for indoor use only. • All modifications to the device will void the warranty. • Repairs are to carry out by skilled personnel only. • Use only fuses of the same type and original parts as spare parts. •...
This machine is not water- or splash-proof. If moisture, water, or fog liquid gets inside the ♦ housing, immediately unplug the unit and contact a service technician or your Varytec dealer before using it again. No user serviceable parts inside. Refer to your Varytec dealer or other qualified service ♦...
Before beginning initial setup of your Varytec Fog Machine, make sure that there is no evident damage caused by transportation. In the event that the unit’s housing or cable is damaged, do not plug it in and do not attempt to use it until after contacting your Varytec dealer for assistance.
The remote unit’s lamp will cycle on and off as the machine re-heats to the proper operating ♦ temperature. For further information on operating your Varytec Fog Machine, see the section titled, “Remote ♦ Control Operation”. If your model includes a mounting bracket designed for overhead installation, it may be installed at floor level or suspended overhead.
Manual key loose in order to stop the fog emission. For control of the DMX settings please refer to the section on Page 6 titled Varytec F-Series Onboard DMX Fog Machine Settings Cleaning your fog machine regularly will help reduce costly parts replacement and repair charges.
Please read and save these instructions Note: In the example above, if the machine were assigned the DMX address of 124, Channel A would correspond to DMX address 124. In general, Varytec fog machines with onboard DMX conform to the following performance specifications: 1.
Page 9
Importer: B & K Braun GmbH Industriestraße 1 D-76307 Karlsbad www.bkbraun.com info@bkbraun.com 9 / 9...
Need help?
Do you have a question about the F-3000 DMX and is the answer not in the manual?
Questions and answers