User Instructions 1. INTRODUCTION Thank you for purchasing a Hayward Robotic Pool Cleaner. We are sure that your Robotic Pool Cleaner will provide you with reliable, convenient and cost-effective pool cleaning. Its reliable filtration in all pool conditions and active brushing, enhance pool hygiene.
4. POOL CLEANER PARTS 5. USING THE POOL CLEANER The PoolCleaner Robotic R130 Robotic Pool Cleaner Model Classic 13/ Classic 13+ Power supply options Filtration options Caddy kit - optional The PoolCleaner Robotic R130 User Instructions...
Attach the floating cable to the power supply by inserting it with the notch on the connector (1), lined up with the groove in the socket on the power supply, and turning clockwise (2). Plug in the power supply and leave it in the OFF position (3). The PoolCleaner Robotic R130 User Instructions...
Make sure that the floating cable is free reached the end of the cleaning cycle. of any obstructions. 5.3 Indicator Lights - Model R130 only Light Indication Blue blinking Normal operation of the Pool Cleaner 5.3.1 Indicator lights. The PoolCleaner Robotic R130 User Instructions...
Using the handle, remove the Pool Cleaner from the pool. DO NOT PULL THE POOL CLEANER FROM THE POOL USING THE CABLE. CAUTION 5.4.3 Place the Pool Cleaner on the edge of the pool and let the water drain out. The PoolCleaner Robotic R130 User Instructions...
Upon opening the filter cover, the handle will lift independently. 6.1.3 Lift up the basket. 6.1.4 Open the latch 6.1.5 Clean the filter basket to release the bottom lid with a hose. in order to remove the debris. The PoolCleaner Robotic R130 User Instructions...
Clean the filter panels with a hose. 6.2.5 Assemble the filter panels according to the following order: Panel 4 — > 3 — > 2 — > 1. 6.2.6 Insert the clean filter basket and close the filter cover. The PoolCleaner Robotic R130 User Instructions...
7.1 If you notice debris trapped in the impeller: Make sure the power supply is switched off and unplugged. CAUTION Clean the debris trapped in the impeller opening, according to the following steps: 7.1.1 7.1.2 7.1.3 7.1.4 The PoolCleaner Robotic R130 User Instructions...
• Roll up the cable so that it has no kinks • Store the Pool Cleaner in a protected area out of direct sun / rain / frost, at a temperature of between 5 °C – 45 °C (41 °F – 113 °F) The PoolCleaner Robotic R130 User Instructions...
If so, adjust the levels and scrub the walls. • Debris stuck in the impeller-house • Remove debris stuck in the impeller-house or impeller-cover or impeller-cover. (according to the drawings). The PoolCleaner Robotic R130 User Instructions...
Page 12
Changes or modifications not expressly approved by Hayward could void the user’s authority to operate this equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
Need help?
Do you have a question about the PoolCleaner Robotic R130 and is the answer not in the manual?
Questions and answers