Chamberlain E940C Quick Start Manual

For use with Chamberlain multi-frequency Garage Door Openers. The code
between the remote control and the receiver changes with each use,
randomly accessing over a billion new codes. Refer to your product manual
for the location of the learn button.
NOTE: Your product may look
in this manual.
Single Button Remote Control
Model E940C
LED
To prevent possible SERIOUS INJURY or DEATH from a moving garage door.
• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate or play with remote controls.
• Activate the garage door ONLY when it can be seen clearly, is properly adjusted, and there are no obstructions to a ect door travel.
•
ALWAYS keep the garage door in sight until it is completey closed. NEVER permit anyone to cross the path of a moving garage door.
PROGRAMMING THE REMOTE USING THE GARAGE DOOR OPENER
ERASING ALL CODES FROM MEMORY
When deactivating any unwanted remote
control code, all previous codes will be
erased.
than the products illustrated
LED
2-Button Remote Control
Model E950C
Press and hold the button on
the remote control or wireless
wall control you wish to use. The
Locate
the learn
button.
FOR ROLLER FOR SECTIONAL
DOOR OPENERS DOOR OPENERS
LED
INDICATOR
LEARN
BUTTON
LEARN
BUTTON
LED
INDICATOR
LED indicator on
the transmitter
will ash
continuously.
TRANSMITTERS
MODELS E940C & E950C
4
Press and
immediately release
the Learn button.
Press and hold the Learn button on the garage door
opener until the learn LED goes out (approximately
6 seconds). All previous codes are now erased.
Reprogram each remote control you wish to use.
The opener
light will ash
or 2 clicks will
be sounded
when it has
learnt the
code.