1. Manuals
  2. Brands
  3. HIKOKI Manuals
  4. Wood Router
  5. M 12VE
  6. Handling instructions manual

HIKOKI M 12VE Handling Instructions Manual

Hide thumbs Also See for M 12VE:

Advertisement

Table of Contents

Router
M 12VE
Read through carefully and understand these instructions before use.
Handling instructions

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the M 12VE and is the answer not in the manual?

Questions and answers

Related Manuals for HIKOKI M 12VE

Summary of Contents for HIKOKI M 12VE

  • Page 1 Router M 12VE Read through carefully and understand these instructions before use. Handling instructions...
  • Page 4 Symbols Handle WARNING Lock pin The following show symbols used for the machine. Be sure that you understand their Wrench meaning before use. To reduce the risk of injury, user must read Loosen instruction manual. Failure to follow the warnings and instructions Tighten may result in electric shock, fi...

  • Page 5: General Power Tool Safety Warnings

    b) Use personal protective equipment. Always GENERAL POWER TOOL SAFETY WARNINGS wear eye protection. Protective equipment such as a dust mask, non- WARNING skid safety shoes, hard hat or hearing protection Read all safety warnings, instructions, illustrations used for appropriate conditions will reduce personal and specifi...

  • Page 6: Router Safety Warnings

    f) Keep cutting tools sharp and clean. ROUTER SAFETY WARNINGS Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier to 1. Hold the power tool by insulated gripping surfaces control. only, because the cutter may contact its own cord. g) Use the power tool, accessories and tool bits Cutting a "live"...

  • Page 7: Prior To Operation

    APPLICATIONS HOW TO USE THE ROUTER ○ Woodworking jobs centered grooving 1. Adjusting depth of cut (Fig. 3) chamfering. (1) Use stopper pole to adjust depth of cut. Place the tool on a fl at wood surface. Turn the stopper block so that section to which the PRIOR TO OPERATION cutting depth setting screw on a stopper block is not 1.

  • Page 8: Using The Optional Accessories

    Insert the guide bar into the hole in the base, adjust the on this tool should ONLY be performed by a HiKOKI distance between the bit and the guide surface, and AUTHORIZED SERVICE CENTER.
  • Page 12 Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99182911 M Printed in China...

Table of Contents