Using the bodypack transmitter
To establish a transmission link, proceed as follows:
1. Switch the receiver on (see the instruction manual of the receiver).
2. Switch the bodypack transmitter on (see next section).
The transmission link is established and the display backlighting of the
receiver changes from red to orange.
It is vital to observe the notes on frequency selection on page 28.
If you cannot establish a transmission link between transmitter and
receiver, read the chapter "Synchronizing the bodypack transmitter with a
receiver" on page 28.
Switching the bodypack transmitter on/off
Push the two battery compartment catches
compartment cover
To switch the bodypack transmitter
Briefly press the
ON/OFF
The bodypack transmitter transmits an RF signal. The
"Frequency/Name" standard display appears on the display
panel. The red
icon
To switch the bodypack transmitter
switch-on
(offline operation):
Keep the
ON/OFF
appears on the display panel.
.
ON/OFF
ON
LED
is displayed.
ON/OFF
button
Using the bodypack transmitter
and open the battery
on
(online operation):
button
.
lights up and the transmission
on
and to
deactivate the RF signal on
pressed until
"RF Mute
On?"
11