Preparing The Transmitter For Use - Sennheiser RS 110 II Quick Manual

Preparing the transmitter for use

The transmitter is prepared for wall mounting (recess at the
rear of the transmitter). The required mounting material
(screws and plugs) is not included in the delivery.
Connecting the transmitter to an audio output of
1
your audio source
Choose a suitable place near your audio source (e.g. TV,
stereo or home cinema system). Avoid placing the trans-
mitter close to metal objects such as shelf bars, reinforced
concrete walls, etc. as this can decrease the transmitter's
range.
Connect the transmitter's audio connection cable:
• either directly to the headphone socket or
• to the 1/4" (6.3 mm) adapter and a corresponding
headphone socket.
Set the volume for the headphone output of your audio
source to a medium level. If the headphone output volu-
me is set too low, the transmitter automatically switches
off.
Some TVs have a function that mutes the TV loud-
speakers when you connect a transmitter. If neces-
sary, change this setting via the operating menu of
your TV.
Connecting the transmitter to the mains
Connect the mains unit to the socket at the rear of the
transmitter. Plug the mains unit into a wall socket. The
transmitter switches on and the
green.
Preparing the headphones for use
Opening the
2
Turn the ear pads in the direction of the arrow until you
overcome a slight resistance and lift them off the ear
cups.
Inserting and replacing the
3
Insert the supplied batteries. Secure the ear pads to the
ear cups.
2
battery compartments
ON/OFF LED lights up
batteries