Airstream NTERSTATE Owner's Manual page 82

ELECTRICAL SYSTEMS
TV ANTENNA
Manufacturer:
Winegard Company
3000 Kirkwood Street
Burlington, Iowa 52601
Phone: 800-843-4741
Raising Antenna to Operating Position
Turn elevating crank in "UP" direction until some resistance
to turning is noted. Antenna is now in operating position.
Check to make sure switch on front TV jack is on.
Rotating Antenna
Make sure antenna is in "UP" position. Pull down on
directional handle with both hands until it disengages
ceiling plate and rotate for best picture and sound on
television set.
H
Lowering Antenna to Travel Position
Rotate antenna until pointer on directional handle aligns
with pointer on ceiling plate.
CAUTION : Antenna must be in "down" position while
traveling to prevent damage.
Turn elevating crank in the "Down" direction until resistance
is noted. Antenna is now locked in travel position.
Checking Operation
1. Tune TV receiver to nearest station and rotate antenna
for best picture and sound.
2. Turn off switch on power supply. Picture on TV receiver
should be considerably degraded with the power off.
DO'S
1. Do check parking location for obstructions before
raising antenna.
2. Do carefully raise, lower and rotate - if difficult, check
for cause.
3. Do rotate slowly when selecting station and check fine-
tuning on TV set to make sure it is properly adjusted.
4. Do lower antenna before moving vehicle.
DON'TS
1. Don't force elevating crank up or down. Check for
cause of trouble.
2. Don't rotate directional handle hard against stops.
3. Don't travel with lift in up position.
4. Don't leave lift part way up or down.
5. Don't apply sealing compound or paint over top of
base plate or anywhere on lift.
H - 7
Raising Antenna
Rotating Antenna
Lowering Antenna