Subscribe to Our Youtube Channel
Related Manuals for Racing RACPBB50
Summary of Contents for Racing RACPBB50
- Page 1 ORIGINAL INSTRUCTIONS PETROL BLOWER RACPBB50 READ THE INSTRUCTIONS BEFORE USE THE TOOL BUILDER SAS 32, rue Aristide Bergès - ZI 31270 Cugnaux – France Made in PRC...
-
Page 2: Safety Warnings
SAFETY WARNINGS WARNING: For your own safety, please read this manual before attempting to operate your new unit. Failure to follow instructions can result in serious personal injury. Spend a few moments to familiarize yourself with your blower before each use. If you give this tool to another person, also hand over this manual. - Page 3 ALL PERSONS WITH RESPIRATORY PROBLEMS and persons operating blower in very dusty environments, should wear a dust particle mask at all times. Paper dust masks are available at most paint and hardware stores. Operate the machine only at reasonable hours - not early in the morning or late at night when people might be disturbed.
- Page 4 cause injury. WARNING: DO NOT ADD, REMOVE OR ALTER ANY COMPONENTS OF THIS PRODUCT. Doing so could cause personal injury and/or damage the unit, voiding the manufacturer’s warranty. DO NOT OPERATE UNIT WHILE TIRED, SICK OR UNDER THE INFLUENCE OF ALCOHOL OR DRUGS.
- Page 5 Maintenance and storage When the machine is stopped for servicing, inspection, or storage, or to change an accessory, shut off the power source and make sure that all moving parts have come to a complete stop. Allow the machine to cool before making any inspections, adjustments, etc.
- Page 6 Symbols Read instruction handbook Risk of projection, keep bystanders away Wear ocular protection and hearing protection Guarantee sound power level Risk of fire Hot surface Risk of inhalation of exhausted gas Intended use This blower is meant to be used for blowing leaves, dust or garden debris into a desired direction.
- Page 7 DESCRIPTION 1. Frame carrier 10. Muffler 2. Side cover 11. Shock absorber 3. Wind cover 12. Flex connector 4. Spark plug cap 13. Bellows 5. Gasoline engine 14. Switch fixing seat 6. Starter handle 15. No.1 wind pipe 7. Fuel tank cap 16.
- Page 8 ASSEMBLY 1. Assemble straight pipe with swivel to the pipe (13). 2. Assemble flexible pipe (13) to elbow (12) on blower. 3. Assemble clamps (A1 and B) onto both extremities and tighten. 4. Loosen wing nut(C) completely, install stick handle clamp (D). Align notches (E) in handle clamp;...
- Page 9 FUELLING AND LUBRICATION Fuel Use a mixture of unleaded gasoline and 2-stroke engine oil for best results. WARNING: Do not pour gasoline directly into the machine. This will cause irreversible damage to the engine and will void the warranty. Do not use a fuel mixture that has been stored for more than 90 days.
-
Page 10: Hot Starting
Starting / Stopping the machine Cold start 1. Turn the switch to position I. 2. Move the choke lever to the CLOSE position (B). 2. Pump the fuel by pressing the priming pump (C) 10 times. 5. Pull the starter grip 4-6 times, until the engine starts (D). 6. -
Page 11: Maintenance
WARNING: Before using your blower, review the Safety Instructions in your user manual, and all regulations for operation of the unit. These precautions and regulations are for your protection. 4. We recommend that a face mask be worn when operating the blower in dusty areas. 5. - Page 12 Carburetor General information Your carburetor comes from the factory with a standard setting. This setting provides an optimum fuel-air mixture under most operating conditions. The high-speed screw alters the engine's power output and the maximum off-load engine speed. If the setting is too lean there is a risk of engine damage due to insufficient lubrication and overheating.
-
Page 13: Specifications
Specifications MODELE............. RACPBB50 Length............... 1870mm Width..............440mm Height ............... 505mm Net Weight............Max. 9.6kg Engine Type............ Air cooled, two-stroke, single cylinder gasoline engine..............1E44F-5 Carburetor............Diaphragm Ignition System..........Flywheel Magneto,capacitor discharge Spark plug............L7RTC Gap (0.6~0.7) mm Exhaust System..........Spark Arrestor Muf er Fuel..............Mixed (Gasoline and Two-stroke Oil) Oil.............. - Page 14 ZI, 32 rue Aristide Bergès – 31270 Cugnaux - France Tel: +33 (0)5.34.502.502 Fax: +33 (0)5.34.502.503 Declares that the machines: PETROL BLOWER Model: RACPBB50 Serial No.: 20200714013-20200714082 The people name holding the technical file：M. Olivier Patriarca Have been designed in compliance with the following standards:...
-
Page 15: Warranty
WARRANTY WARRANTY The manufacturer guarantees the product against defects in material and workmanship for a period of 2 years from the date of the original purchase. The warranty only applies if the product is for household use. The warranty does not cover breakdowns due to normal wear and tear. The manufacturer agrees to replace parts identified as defective by the designated distributor. -
Page 16: Product Failure
PRODUCT FAILURE WHAT TO DO IF MY MACHINE BREAKS DOWN? If you bought your product in a store: a) Empty the fuel tank. b) Make sure that your machine is complete with all accessories supplied, and clean! If this is not the case, the repairer will refuse the machine. -
Page 17: Warranty Exclusions
WARRANTY EXCLUSIONS THE WARRANTY DOES NOT COVER: • Start-up and setting up of the product. • Damage resulting from normal wear and tear of the product. • Damage resulting from improper use of the product. • Damage resulting from assembly or start-up not in accordance with the user manual. •...
Need help?
Do you have a question about the RACPBB50 and is the answer not in the manual?
Questions and answers