Muting The Audio Signal; Selecting A Standard Display - Sennheiser EM 2000 - 01-09 Instruction Manual

Using the receiver
16

Muting the audio signal

To mute the audio signal:
When one of the standard displays is shown on the display panel, press the
STANDBY button.
"RX Mute On?" appears on the display panel.
Press the jog dial.
The audio signal is muted.
standard display. The display panel is backlit in red.
To unmute the audio signal:
Press the STANDBY
"RX Mute Off?" appears on the display panel.
Press the jog dial.
The muting is canceled and the display backlighting changes from red to orange
again.
If "RX Mute On?" or "RX Mute
change the status of the muting function:
Press the STANDBY
The status of the muting function remains unchanged and the current standard
display appears.

Selecting a standard display

Turn the jog dial to select a standard display:
Contents of the display
B.CH: 20.64 **2000**
PEAK
40 0
543.200 MHz
-10
30
-20
20
-30
EQ: SKM2000
10
-40
P + 12dB
MUTE
RF AF
543.200 MHz
PEAK **2000**
40 0
SKM2000
-10
30
935
-20
20
-30
10 Standard
-40
P – 12dB MUTE
RF AF
PEAK
Soundcheck
40 0
-10
30
20.64
**2000**
-20
20
543.200 MHz
-30
10
-40
P
MUTE
RF AF
PEAK 543.200 MHz **2000**
40 0
-10
30
MUTE
-20
20 440 Hz
-30
10
-40
RF AF
* The reading of the transmitter parameters can take up to 2 minutes. If you synchronize
your transmitter with the receiver (see page 15), the parameters are read out without
delay.
** The "Guitar Tuner" standard display is deactivated upon delivery. To show this standard
display, you have to activate it (see page 27).
"RX Mute" flashes in alternation with the current
button.
Off?" appears on the display panel but you do not wish to
button.
Selectable standard display
"Receiver Parameters"
appears after switch-on of the receiver and displays the
receiver parameters (see page 7)
"Transmitter Parameters"*
(transmitter type/microphone, inverted display)
displays the microphone head (SKM only) and the transmitter
type
"Soundcheck" (display with additional function)
displays the signal quality within the transmission area
(see page 21)
"Guitar Tuner"** (display with additional function)
displays the guitar tuner (see page 21)