Subscribe to Our Youtube Channel
Related Manuals for Chicco BENTO
Summary of Contents for Chicco BENTO
- Page 1 Read all instructions BEFORE assembly and USE of product. KEEP INSTRUCTIONS FOR FUTURE USE. BENTO ™ 3-in-1 Booster Chair Owner's Manual IS0230E_01 10/23 © 2023 Artsana USA, Inc. ChiccoUSA.com...
-
Page 2: Parts List
WARNING Failure to follow the warnings and the Parts List instructions throughout this booklet could result in serious injury or death. Each mode has specific warnings, make sure to read and understand the warnings in each mode. A. - Seat Base This product can be used in the following modes: B. -
Page 3: Assembling The Seat
Components Assembling the Seat “CLICK!” 1. On the bottom of the Booster Seat, locate the Booster Legs. Rotate both Legs out until they lock with a click, as shown. “CLICK!” A - Backrest H - Carry Handle B - Rear Attachment straps I - Tray Attachments J - Tray Horn C - Lower Attachment straps... - Page 4 Assembling the Seat Assembling the Seat WARNING 2. To unfold the Booster Seat, The tray is not designed to hold the child in the chair. squeeze the Fold Lever and lift up on the Seat Back until it locks with a click. 3.
- Page 5 • Prevent serious injury or death. entangled. Do not use in motor vehicles. • Do not attach any parts to the • Use this booster only for product that are not supplied or children capable of sitting upright expressly approved by Chicco. unassisted.
- Page 6 Attaching the Booster Seat to a Chair Attaching the Booster Seat to a Chair High Position Install: 7. Make sure the Booster Legs are not overhanging the 5. Center the seat on the chair, chair seat and the Booster making sure the back of the is centered, then secure the Booster by fully tightening the Booster Legs are against the...
- Page 7 Attaching the Booster Seat to a Chair Attaching the Booster Seat to a Chair 9. Center the seat on the chair, making sure the back of the Booster Seat is against the chair back. Low Position Install: 8. To Fold the Booster Seat 10A.
- Page 8 Removing the Tray Attaching the Booster Seat to a Chair 12. To remove the Tray from 11. Make sure the Booster the Tray Supports, pull out on Legs are not overhanging the both side tabs and lift up. chair seat and the Booster is centered, then secure the Booster by tightening the Rear and Lower Attachment Straps...
- Page 9 • Do not attach any parts to the The length of the Crotch Strap product that are not supplied or can be adjusted by pulling on expressly approved by Chicco. the adjustment buckle to tighten or loosen.
- Page 10 • Do not leave the product near walls, curtains, or windows, where the child can become entangled. • Do not attach any parts to the product that are not supplied or expressly approved by Chicco. • DROWNING HAZARD: NEVER use in or near water.
- Page 11 Removing the 3-point Harness Straps Removing the 3-point Harness Straps Refer to previous section for tray 16. Loosen the Waist Belt Strap removal (step 7). Tab, then push the Waist Belt Strap down into the opening in 15. Undo the harness buckle. the Seat bottom, as shown.
-
Page 12: Cleaning And Maintenance
MAINTENANCE Periodically check the product for loose screws, or worn parts. Replace or repair the parts as needed. Use only Chicco replacement parts. Keep product in a dry place. Prolonged exposure to direct sunlight may cause plastic parts to warp. - Page 13 For More Information For USA customers : If you have any questions or comments about this product, or are missing any of the parts, please do not return this product to the store. Contact us in one of the following ways: (877)-424-4226 info.usa@artsana.com www.chiccousa.com...
Need help?
Do you have a question about the BENTO and is the answer not in the manual?
Questions and answers