Assa Abloy Corbin Russwin IN120 Series Installation Instructions Manual page 12

4
IN220 (PoE) Installation Wiring (Continued)
Frame Harness Installation
A
Supplied by CI
B-Splice
Crimp Connector
Ceiling
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable drain wire
concealed in
shrink tubing
Molex-M
PoE Data Hinge
B
Frame
4-pin M
6-pin M 6-pin F
Components and wire harness supplied by McKinney. Suggested installation:
Cut end / ceiling-side PoE harness:
RJ45-M
Do not confuse pair numbers with pin numbers. A pair number is used for
reference only (eg: 10BaseT Ethernet uses pairs 2 & 3). The pin numbers
indicate actual physical locations on the plug and jack.
Hinge side of PoE (Frame) harness:
1. Feed cut end of harness into hole on hinge-side through single access hole.
2. Push one connector back through the hole and feed into the other access hole.
Each of the hinge-side harness connectors should end up threaded through a
different access hole and matched to the same size pin connector from
the door harness:
• 4-pin male molex connector
• 6-pin male molex connector with ground wire
4-pin F
PoE Hinge
FM593 09/23
TIA/EIA 568-B Standard Wiring
pin pin
1 8
8 1
4-pin F
Hinge-side harness connectors:
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
Lock-side harness connectors:
6-pin F
• 4-pin female molex connector
• 6-pin female molex connector with ground wire
12 Copyright © 2016, 2019, 2021-23, ASSA ABLOY Access and Egress Hardware Group, Inc.
All rights reserved. Reproduction in whole or in part without the express written
permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
IN120 & IN220 Series
PED5000 Series
Exit Devices
PIN Wire Pair Num-
1 White/Orange
2 Orange
3 White/Green
4 Blue
5 White/Blue
6 Green
7 White/Brown
8 Brown
ber
2
2
3
1
1
3
4
4