Table of Contents
Advertisement
6
To adjust the time zone and time by GPS signal reception (time zone adjustment)
Time zone adjustment
The time zone where you are is localized to adjust the watch to the precise current time by just one button operation
anywhere in the world.
This reflects the data regarding the adoption of DST (Daylight Saving Time) in the country that received the GPS signals.
The time automatically switches to adjust for the adoption and duration of DST (Daylight Saving Time) for countries
that follow DST (Daylight Saving Time).
"Normal time" always appears for countries that do not adopt DST (Daylight Saving Time).
How to adjust the time zone
Go to a place where GPS
1
signals can be easily received
Move to the outdoors under an
open sky with good visibility.
Precautions on time zone adjustment
If the time zone is adjusted near a time zone boundary, the time of the adjacent time zone may be displayed. In some areas the boundaries observed by the watch may not exactly
correlate to the actual time zone markers on the land. This does not indicate a malfunction. In this case, set the time zone in the manual time zone setting mode.
When the time zone is adjusted while traveling on land, avoid time zone boundaries to carry out time zone adjustment in the representative cities in the time zone whenever
possible. In addition, when the watch is used near time zone boundaries, make sure to check the time zone setting, and manually set the time zone as necessary.
Continue to press Button B (3 seconds),
2
and then release it when the seconds
hand moves to the 30-second position
When the seconds hand has reached
the 30-second position, reception is
started.
The multi-function indicator hand points
to "4+".
Press for
3 seconds
* While the multi-function indicator
hand points to "low,"
or "CHR",
reception is not started even with
operation for reception.
* When the hand points to "low,"
charge the watch by exposing it to
light.
* When the hand points to
, turn
off the in-flight mode (
).
* When the hand points to "CHR", turn
off stopwatch mode.
Direct the watch face
3
upward and wait
* Please note that it may be difficult to receive
GPS signals while you are in motion.
It takes a maximum of
2 minutes to complete
reception.
* It depends on the
receiving conditions.
< Display during reception (= satellites
acquisition status) >
The seconds hand
0 units
indicates ease of
receiving (= number
of GPS satellites from
which GPS signals
are received).
5 units
6 units
* The larger the number of acquired satellites there
are, the easier it is to receive GPS signals.
Number of satellites
Ease of reception
4 units or more
Easy to receive
3 units
May receive
0-2 units
Cannot receive
* Even when the hand points to 4 units or more,
reception may not be allowed.
* To cancel the
reception, press
Button B.
8
When the seconds hand points to
4
"Y" or "N", reception is completed
The reception result is displayed
for 5 seconds.
If reception is successful, the time
and date are adjusted.
The settings for the time zone and
DST (Daylight Saving Time) are
reflected in the time that appears.
Reception
Y: Successful
result
(8-second
display
position)
2 units
Display
3 units
4 units
Use the watch as it
State
is.
* The buttons cannot be operated
while the hour and minute hands,
multi-function indicator hand, or sub-
dial is moving.
Press Button
B
N: Failed
(52-second
position)
Advertisement
Table of Contents
