CONTENTS General information Important safety instructions .................. 4 Unpacking and installation ..................4 Electrical connection ....................5 Start-up of the cabinet ................... 5 Thermostat ......................6 Defrosting ......................6 Moving the shelves ....................7 Door reversal ......................7 Cleaning and maintenance ..................7 Service ........................
IMPORTANT SAFETY INSTRUCTIONS Before you use your cooler please read this instruction manual carefully. This appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved.
ELECTRICAL CONNECTION The cabinet operates on 220-240 V/50 Hz. The wall socket should be easily accessible. All earthing requirements stipulated by the local electricity authorities must be observed. The cabinet plug and wall socket should then give correct earthing. If in doubt, contact your local supplier or authorized electrician.
THERMOSTAT The thermostat and the light switch is placed in the bottom panel. The thermostat has been pre-set and in most cases it is not necessary to adjust the settings. When turning on the cabinet the display will show the current temperature in the cabinet. Display set temperature: Press this key and the display will show the set temperature.
MOVING THE SHELVES The shelf guides is moved by squeezing them together and lifting them upwards at the same time. Check that all 4 shelf guides are placed in the same height before placing the shelf in the cabinet. DOOR REVERSAL Single door cabinets only ! Remove the 3 screws in the bottom hinge and let the door slide out of the top hinge.
Page 9
Specifications subject to changes without prior notification.
Page 10
DT-01 TECHNICAL MANUAL Set point (SP): Check the set point: Push and immediately release the SET key, the set point will be showed, no LED blinking. It will return to normal temperature display after 5s without pressing a key. Change the set point: Push the SET key for 2s to change the set point value.The value of the set point will be displayed and the “°C”...
Page 11
DT-01 PARAMETER LIST Description Range Default Remarks Set point Cut-out temperature "-55~99°C / -67~99 °F" Differential Intervention differential for set point. When the "0.1~25°C / temperature ≥SP+dF, compressor Cut IN , when 1~45°F" the temperature ≤SP, compressor Cut OUT. Minimum set point Set the minimum value for the set point.