Specifications - Pioneer SX-535 Service Manual

1. SPECIFICATIONS
SEMICONDUCTORS
FET.. . 1
ICs . 3
Transistors. 29
Diodes. 15
AMPLIFIER SECTION
Continuous Power Output
20H2~20kHz (Both channels
driven) ... 20W + 20W (8f2, Rated power)
22W + 22W (4^)
1kHz (Both channels driven) . . . 22W + 22W (8^), 25W + 25W (457)
Harmonic Distortion
(40Hz~20kHz Continuous Power
Output). Less than 0.8%
(1W + 1W, Power Output) ....
Less than 0.08%
Intermodulation Distortion
(Continuous Power Output) . . . Less than 0.8%
(1W + 1W, Power Output).
Less than 0.08%
Power Bandwidth
(IHF, Both channels driven) . . . 10Hz~70kHz (T.H.D. 0.8%)
Output Speaker .
A, B, A + B, (4^7-16J7)
Headphone . 4n~16fi
Damping Factor (1 kHz, 857}. More than 30
Residual Hum & Noise
(8r7, Pre & Power amplifier) . . . Less than 0.5mV
Input Sensitivity/Impedance
PHONO ./. . .
2.5mV/50kn
PHONO Overload Level (rms/p-p) 110mV/31 OmV
MIC..
7mV/85kJ7
AUX.;.
150mV/75k^7
TAPE PB 1, 2.. 150mV/75kJ7
TAPE PB 2 (DIN connector) . . . 150mV/75k57
Output Level/lrapedance
TAPE REC 1,2. 150mV
TAPE REC 2 (DIN connector) . .
30mV/80kJ7
Frequency Response
PHONO (RIAA equalization) . . . 30Hz~l5kHz±0.5dB
AUX, TAPE PB .
20Hz~30kHz±1dB
Tone Control
BASS .
+9dB, -8dB (100Hz)
TREBLE . .
±6dB (10kHz)
.Loudness Contour (Volume control
set at —40dB position) .
+ 10dB (100Hz), +5dB (10kHz)
Hum & Noise (IHF, short-circuited, A Network)
PHONO ....
More than 70dB
MIC.
More than 65dB
AUX. TAPE PB
More than 90dB
3