Before You Begin - Panasonic Digital Palmcorder PV-DV201 Operating Instructions Manual

• If
the Palmcorder is connected to a power
source, the cassette can be inserted and
ejected without turning the Palmcorder
on. 1 TAPE EJECT
Switch
3
CLOSE mark
ipefore you begin
Connect the Palmcorder to a power /
source. (See pages 11, 12.)
J
Slide TAPE EJECT to open the
Cassette Compartment Cover.
Insert a cassette record tab up,
window side facing out.
Press PUSH TO CLOSE mark to
close the Cassette Compartment
Cover.
• To remove the cassette...
Slide TAPE EJECT to open the Cassette
Compartment Cover and pull the cassette
Cassette Compartment Cover tape straight out.
Hint to locate recording position when inserting cassette
• When you insert a partially recorded cassette, use the Edit Search Function (see page
24) to visually confirm the point at which you want to start a new recording. Especially
advisable when you want to add a recording to a tape that is already full.
Note J
i lf hand strap is tight it may prevent Cassette Compartment Cover from fully opening
for tape insertion or ejection. Loosen hand strap it necessary.
When inserting the cassette, make sure it faces in the right direction and then push in
completely.
To brighten the natural colors in a scene.
,_Built-in Light Mount
• Using the light will reduce battery
operating time.
• Be sure to provide
adequate ventilation if using Light in a
hot environment for an extended period.
• Be sure LIGHT is set to OFF when not in
use.
• Do not attempt to lift or carry the
Palmcorder by holding the Enhancement
Light.
• If light bulb needs to be replaced, take
Light to your nearest authorized
servicenter.
-Before you begin
• Connect the Palmcorder to a power
source. (See pages 11, 12.)
• Set POWER to CAMERA or M-CARD.
1
2
Slide Light into the Built-in Light
Mount.
Be sure it locks into place.
2LIGHT Button
Press LIGHT to turn __L
ON or OFF.
LIGHT RELEASE Button
To remove the Light:
Press LIGHT RELEASE and sJide the
Light out of the mount.
-Caution
This light becomes hot during operation.
Make sure nothing covers the Light
during operation.
7