GemOne Sapphire V2SC Procedures Manual
Hide thumbs
Also See for Sapphire V2SC:
- Hardware installation (33 pages) ,
- Procedures manual (14 pages) ,
- Hardware operation manual (13 pages)
Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for GemOne Sapphire V2SC
Summary of Contents for GemOne Sapphire V2SC
- Page 1 Sapphire V2SC Cameras Procedure Manual Version 1.2 - May 2024...
-
Page 2: Table Of Contents
Content 1 - Safety Precautions 2 - Introduction - Purpose - Scope 3 - Kit Components - Mast View Camera Kit or Rear View Camera Kit - Mast View & Rear View Camera Kit - Fork View Camera Kit 4 - Component Information - Camera Cable Input Triggers - SD Card... - Page 3 12 - Camera Application - General Information - Application Settings Mast & Rear View Cameras Fork View Cameras - Functions Preview Number Camera View Enlarging AHD1 Enlarging AHD2 Take a picture Mirror Normal Image Mirrored Image Playback 13 - Appendix A - SD CARD FORMAT 14 - Support...
-
Page 4: Safety Precautions
Doing so may crack the screen or LCD panel glass, resulting in personal injury or major damage to the device. Power Supply Do not use the Sapphire V2SC with any voltage other than that specified. Avoid situations that can cause damage to the power cable. Sapphire V2SC Cameras... -
Page 5: Introduction
2 - Introduction Purpose This document is to be used as a guide to install cameras with the Sapphire V2SC display. It can be fitted onto various types of equipment, whether they are internal combustion or electric. Scope This document is to be used by a trained and authorized person(s) with the necessary PPE as a guide for the installation, operation, and management of the Sapphire V2SC and cameras. -
Page 6: Kit Components
Rear View Camera Kit & Rear View Camera Kit Mast or Rear View Camera Mast View & Rear View Camera Camera Cable Camera Cable Camera Extension Cable 2 x Camera Extension Cable 512GB SD Card 512GB SD Card Sapphire V2SC Cameras... -
Page 7: Fork View Camera Kit
Fork View Camera Kit Fork View Camera (Varies) Camera Cable & Carriage Mount Camera Extension Cable 512GB SD Card 1 x Coil Cable Cable 1 x Conversion Cable Sapphire V2SC Cameras... -
Page 8: Component Information
= input 4 to trigger AHD4 The GND wire is optional and is not always mandatory for inputs to trigger. It is only required if the triggering circuit is on a different GND to the Sapphire V2SC device. Sapphire V2SC Cameras... -
Page 9: Sd Card
Once the SD card is full, it will overwrite older files. A prompt can be configured on the app to notify the operator on the V2SC display that the SD card is approaching full capacity. See sections below for more information. Sapphire V2SC Cameras... -
Page 10: Camera Connection
5 - Camera Connection Preparation Ensure the Sapphire V2SC display is completely off before removing the cap and connecting the camera cable. Removing the Cap There is a cap at the back of the V2SC display that covers the camera connector. -
Page 11: Connecting The Cable
Inserting the SD Card There is a small cap on the right hand side of the Sapphire V2SC that covers the SD card slot. Remove this cap by undoing the small screw and then insert the SD card. The SD card will click in place once secured. -
Page 12: Mast View Camera Overview
Sapphire V2SC Cameras... -
Page 13: Rear View Camera Overview
Sapphire V2SC Cameras... -
Page 14: Mast View & Rear View Camera Overview
Sapphire V2SC Cameras... -
Page 15: Fork View Camera Overview
Sapphire V2SC Cameras... -
Page 16: Fork View Camera Installation
7. Tie off the camera cabling securely but take care not to pinch or cut the cable by pulling the cable ties too tight 8. Tighten carriage hook screws as needed, lower screw first, then the top screw to secure the camera to the carriage Sapphire V2SC Cameras... -
Page 17: Coil Cable Mounting
Remount and re-connect the coil cable. Check for proper operation. Coil cables may do this when very new or if they have been over stretched. Sapphire V2SC Cameras... -
Page 18: Camera Application
General Information Cameras on the V2SC can be accessed via the camera app. This is accessible after logging into the Sapphire V2SC device and can be found on the top right corner of the display. There are two types of views: 1. - Page 19 Tick channel 1 if only one camera is connected to AHD1 b. Tick channel 2 as well if there are two cameras connected; one camera to AHD1 and another camera to AHD2 Sapphire V2SC Cameras...
-
Page 20: Fork View Cameras
Touching a camera feed will enlarge that video on the display. This can be done manually or by connecting the inputs from the camera harness. Refer to the camera input section above for more information. • Touching the feed again will revert back to the previous screen. Sapphire V2SC Cameras... -
Page 21: Enlarging Ahd1
CH4 corresponds to AHD4. • being inserted and formatted correct. The examples below show The display will say TAKE PICTURE the difference between a normal END if a picture has been and mirrored image. successfully taken Normal Image Mirrored Image Sapphire V2SC Cameras... -
Page 22: Playback
This is only available for the supervisor. Change the destination from Recent • Footage and images can be viewed to SanDisk SD Card and then directly from the display. the saved files will appear Touch the PLAYBACK button to bring up additional options. Sapphire V2SC Cameras... -
Page 23: Appendix A - Sd Card Format
2. Close all the apps and then it will go 4. Go into storage to the main display 5. Select SanDisk 6. Select the 3 dots on the top right 7. Select storage settings 8. Select Format Sapphire V2SC Cameras... - Page 24 9. Format the SD card 10. Press Done 11. Press the home button to open up the sapphire app and then the process is complete. Sapphire V2SC Cameras...
-
Page 25: Support
+32 56 93 01 08 +1 (844) 656-1156 support_emea@gemone.com techservice@gemone.com EMEA Spinnerijstraat 99/23 US 16355 South Elm Rd 8500 Kortrijk Olathe, Kansas 66062 Belgium ASEA +61 1300 848 415 support_apac@gemone.com 735 Boundary Road Richlands, QLD 4077 Australia Sapphire V2SC Cameras... - Page 26 US: techservice@gemone.com EMEA: support_emea@gemone.com ASEA: support_apac@gemone.com www.gemone.com ©2024 - GemOne NV, Spinnerijstraat 99/23, BE- 8500 KORTRIJK. All rights reserved. No part of this publication may be reproduced or communicated in any form or by any means, electronic or mechanical, including copying, recording or use in an information storage or retrieval system, without prior and explicit permission of GemOne NV.
Need help?
Do you have a question about the Sapphire V2SC and is the answer not in the manual?
Questions and answers