Periodic Inspections; Brush Replacement - Makita VS001G Instruction Manual

Periodic inspections

To ensure a long service life for the appliance and
safety usage, perform the inspections listed below
periodically.
Daily inspections
• Waste container: empty the container.
• Filters: if they are dirty, cleaning them.
• Brushes: if string-like refuse get entangled,
remove it.
• Control and movable parts: check that they move
smoothly.
Weekly inspections
• Main brush height: if the height is inappropriate,
readjust it.
• Screws (when using multifunction adapter): if they
are loose, tighten them.
Replacement/replenishment of
consumable items

Brush replacement

If the main brushes and side brush become worn out,
ask your local Makita service center for replacement.
Replacing the main brushes
Replace the main brushes if they cannot be adjusted
appropriately. Refer to "Main brush height adjustment."
For removing and mounting the main brushes, refer to
"Cleaning the main brushes."
Replacing the side brush
Replace the side brush if it does not contact the floor
when the side brush height adjusting knob is turned to
the lowest position. Refer to "Side brush height adjust-
ment."
For removing and mounting the side brush, refer to
"Attaching and removing the side brush."
Makita Corporation
3-11-8, Sumiyoshi-cho,
Anjo, Aichi 446-8502 Japan
www.makita.com
885A57-929
EN
20231204