Self Clean Operation; Auto Restart Function; Tips For Effective Operation - Mitsubishi Heavy Industries SRK100ZRA-W User Manual

SELF CLEAN operation

■ SELF CLEAN operation should be run after AUTO, COOL and DRY operation to remove the moisture from inside of the indoor unit and
control the growth of mold and bacteria.

Auto restart function

■ Auto restart function records the operational status of the air-conditioner immediately prior to be switched off by a power cut, and then
automatically resumes operations after the power has been restored.
■ The following settings will be canceled:
1 Timer settings
2 HIGH POWER operations
NOTE
• Auto restart function is set at on when the air-conditioner is shipped from the factory. Consult with your dealer if this function needs
to be switched off.
• When power failure occurs, the timer setting is canceled. Once power is resumed, set the timer again.

Tips for effective operation

■ Please observe the following for the most economic and comfortable use of your unit.
• Set a suitable room temperature.
Excessively high or low temperatures are not good for your health and waste of electricity.
• Clean the filters frequently.
Clogged filters may block the airflow and cause less efficient operation.
• Avoid direct sunlight and draught.
Cut out direct sunlight by drawing the curtains or blinds when cooling. Keep windows and doors shut, except when ventilating.
• Adjust the airflow direction properly.
Adjust the up/down and left/right airflow to ensure a steady room temperature.
• Operate the unit only when needed.
Use the timer properly to operate the unit only when needed.
• Keep heat source away when cooling.
Keep heat sources out of the room as much as possible.
1
In order to active SELF CLEAN operation, press the
CLEAN switch with the tip of a ballpoint pen.
Every time the CLEAN switch is pressed, the display is switched in the
order of:
(SELF CLEAN on)
NOTE
• Two hours later, the air-conditioner stops SELF CLEAN operation au-
tomatically. To stop the air-conditioner immediately, press the ON/OFF
button.
• SELF CLEAN operation is not operated after HEAT, FAN, OFF TIMER,
SLEEP and ALLERGEN CLEAR operations have fi nished.
• The indoor unit fan runs for about two hours in SELF CLEAN operation.
• The RUN light illuminates during SELF CLEAN operation.
• Pressing the SLEEP button, ALLERGEN CLEAR button or NIGHT
SETBACK button during SELF CLEAN operation cancels the SELF
CLEAN operation and then the unit is set to SLEEP, ALLERGEN CLEAR
or NIGHT SETBACK operation.
• This is not a function for removing mold, germs or grime that have
already adhered to the unit.
Page 27
– 26 –
No display
(SELF CLEAN off)
3 seconds
ON
OFF
1 second