Playing The Entire Disc; Information Display - Sony CDP-397 Operating Instructions Manual

1 Press the & OPEN/CLOSE button and place a
disc on the tray.
@OPENICLOSE
2 Press the Pil (>) button.
To stop play
To stop for a moment during play, press the Pil (If) button.
To resume play, press the fl (> orf.) button again.
To stop play, press the B button.
To stop play and open the tray, press the & OPEN/CLOSE
button.
For private listening
Connect a pair of headphones to the PHONES jack.
To increase the volume, turn the PHONE LEVEL control
clokwise.
To decrease it, turn the control counterclokwise.
Note on timer connection
When the power is turned on and a disc is in the CD player,
connect the power cord of the player to timer.
When the preset time has arrived, playback starts
automatically.
ab colguerchdlelam OltJe) (hi
Each time you press the TIME button during play, the display
changes to give you the following information.
a) Elapsed playing time
b) Remaining time in a selection
If the current selection number is over 20, "- -.-— "is
displayed.
c) Remaining time of the disc
However, "- -. - —" is displayed instead of the actual time
in the following cases.
*lf a disc with more than 20 selections is being played in
shuffle play or delete play mode.
elf any one selection the number of which is greater than
20 has been programmed.
elf the remaining time exceeds 100 minutes.
)
a
a
a
a
8
a
a
a
a
a
a
a
a
t
a
a
a
5
ta
Snuenane 8
Note
The time display mode selected with the TIME button wil not change until the power
ts tumed off.
To check the total time and total number of selections
Press the TIME button in stop mode.
The total number of programmed selections wil be displayed if a program 1s stored