(Only For Cdp-397); Hooking Up The System; Notes 01 Connection - Sony CDP-397 Operating Instructions Manual

Inserting the Batteries into the Remote
Commander (only for CDP-397)
You can control the unit with the supplied remote
commander.
Insert two size AA (R6) batteries with the correct polarity.
1 Slide the cover to remove it.
2 insert two size AA (R6) batteries correctly so that
the © and 9 polarities match the polarity
diagrams inside the battery compartment.
On battery life
¢ About half a year of normal operation can be expected
when using size AA (R6) batteries.
¢ When the batteries are run down, the remote commander
will not operate the unit. In this case, replace both
batteries with new ones.
Notes on the remote commander and remote control
Operation
¢ Keep the commander away from extremely hot or humid
places.
¢ Avoid dropping any foreign objects into the commander
casing, particularly when replacing the batteries.
¢ Avoid exposing the remote sensor to direct sunlight or
lighting apparatus. Such exposure can cause a
malfunction.
* To avoid damage caused by battery leakage and
corrosion, remove the batteries when the commander will
not be used for a long time.
Convention
This indicates a function operated only on the
main unit.
Hooking Up the System
Connect the unit to an amplifier as shown below.
iN Ko) (otomro) alm Ole) alat-toi rela)
ae you begin, remember the following.
Tur off the power of each unit before making
connections. Connect the AC power cord last.
¢ Be sure to insert the plugs firmly into the jacks. Loose
connection may cause hum and noise.
¢ Leave a little slack in the connecting cord to allow for
inadvertent shock or vibration.
Compact disc player