Recording A Program (Only For Cdp-397); Programming And Recording - Sony CDP-397 Operating Instructions Manual

Recording a Program (only for CDP-397)
You can make a program by designating up to 24 selections in desired order . At the
same time, you can adjust the total playing time of the program, so that you can
make the program fit the length of a tape when recording.
eumele}e-lanlanlialemslalemat-rexeyce| (are)
1 Press the PROGRAM button.
"PROGRAM" appears in the display.
PROGRAM
2-A
Press the numeric buttons of the desired
selections in desired order (only on the remote
commander).
by
Last programmed selection
The order to be played Programmed selection
numbers
After one second, the total playing time is displayed.
To select a selection number over 10, see page
9.
if you choose wrong selections
Each time you press the CLEAR button, the last
chosen selection is deleted.
2-B
1) Press the I44 44 (44) or D> PPI (> PI) button to
change a selection and check the time. — Program
edit
Last selection
Total playing time Selection numbers
Total playing time of selections is displayed
If satisfactory, go to the next step. If not, choose
another selection.
2) Press the PROGRAM button to store the
selection.
Step number appears in the display for a while.
3) Repeat steps 1) and 2)
3 Press the lf button on the remote commander to
make a program for side B.
"P" is displayed in the display and the total playing
time is reset to 0. A pause is also counted as a
selection.