Changing Door Stop; Special Accessories - AEG LAVATHERM 59880 User Manual

Changing door stop

WARNING!
Before changing the door stop, disconnect the mains plug.
1. Open loading door.
Unscrew hinge A from the front of the
2.
appliance and take off the loading door.
Remove cover plates B. To do this, insert
3.
a thin screwdriver into the slots as
shown in the illustration, push down-
wards slightly and pry out the cover
plates.
Use an appropriate tool and exert pressure to unfasten locking block C from the snap-
4.
on fixture, take out and re-insert on the other side having rotated the block through
180°.
Unscrew hinge A from the loading door, rotate through 180°, re-insert on the opposite
5.
side and screw down.
Re-insert cover plates Bon the opposite site having first rotated them through 180°.
6.
Unscrew cover plates D from the front
7.
of the appliance, rotate through 180°,
screw on the opposite side.
Unscrew door lock E, push down slightly
8.
and remove from the front of the appli-
ance.
Push snap-in button F in and down,
9.
push cover down slightly and remove from front of the appliance.
10. Change door lock E over to the opposite side, screw down the door interlock.
11. On the other side, insert cover F and allow snap-in button to lock into place.
12. Insert loading door and hinges into recesses on the front of the appliance and screw
down.
Note regarding contact protection: The appliance is only secure for operations again
once all plastic parts have been inserted.

Special accessories

• Stacking kit
These intermediate installation kits can be used to arrange the dryer and a washing ma-
chine (60 cm wide, front loaded) as a space-saving washer/dryer stack. The washing ma-
chine is at the bottom and the dryer is at the top.
Read carefully the instructions supplied with the kit.
Available from your Service Force Centre or your specialist dealer
• Draining kit
Installation kit for direct draining of the condensed water into a basin, siphon, gully, etc.
The water reservoir then no longer has to be drained, it must however remain in its in-
tended position in the machine.
Installation
A
C
B
A
D
E
F
E
D
39
B
F