Removing Transport Safety Packaging; Electrical Connection; Changing Door Stop - AEG 7023 TK ELECTRONIC User Manual

• Once in its permanent operating position, check that the dryer is absolutely level with
the aid of a spirit level. If it is not, raise or lower the feet until it is.
• The feet must never be removed. Do not restrict the floor clearance through deep pile
carpets, strips of wood or similar. This might cause heat built-up which would interfere
with the operation of the appliance.
• The hot air emitted by the tumble dryer can reach temperatures of up to 60°C. The
appliance must therefore not be installed on floors which are not resistant to high tem-
peratures.
• When operating the tumble dryer, the room temperature must not be lower than +5°C
and higher than +35°C, as it may affect the performance of the appliance.
• Should the appliance be moved, it must be transported vertically.
• The appliance must not be installed behind a lockable door, a sliding door a door with a
hinge on the opposite side to that of the appliance in such a way that a full opening of
the dryer is restricted.

Removing transport safety packaging

CAUTION!
Before use all parts of the transport packaging must be removed.
1. Open loading door
2. Pull off adhesive strips from inside ma-
chine on top of drum.
3. Remove foil hose and polystyrene pad-
ding from the machine.

Electrical connection

Details on mains voltage, type of current and the fuses required should be taken from the
type plate. The type plate is fitted near the loading aperture (see "Product description"
chapter).
Connect the machine to an earthed socket, in accordance with current wiring reg-
ulations.
WARNING!
The manufacturer declines any responsibility for damage or injury through failure
to comply with the above safety precautions.
Should the appliance power supply cable need to be replaced, this must be carried
out by our Service Center.
WARNING!
The plug must be accessible after installing the machine.

Changing door stop

WARNING!
Before changing the door stop, disconnect the mains plug.
69
Installation