Technical Data; Installation - Electrolux IK224020 User Manual

Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

TECHNICAL DATA

Dimension of the recess
Voltage
Frequency
The technical information are situated in the
rating plate on the internal left side of the
appliance and in the energy label.
INSTALLATION
Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
Install this appliance at a location where the
ambient temperature corresponds to the
climate class indicated on the rating plate of
the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Removing the shelf holders
Your appliance is equipped with shelf re-
tainers that make it possible to secure the
shelves during transportation.
To remove them proceed as follows:
1. Move the shelf holders in the direction
of the arrow (A).
2. Raise the shelf from the rear and push
it forward until it is freed (B).
3. Remove the retainers (C).
3. If necessary, replace the defective door
Height
Width
Depth
Electrical connection
Before plugging in, ensure that the voltage
and frequency shown on the rating plate
correspond to your domestic power supply.
The appliance must be earthed. The power
supply cable plug is provided with a contact
for this purpose. If the domestic power sup-
ply socket is not earthed, connect the appli-
ance to a separate earth in compliance with
current regulations, consulting a qualified
electrician.
gaskets. Contact the Service Center.
1225 mm
560 mm
550 mm
230-240 V
50 Hz
electrolux 43