Smeg TLS10 Instructions For Use Manual page 15

Description of failure indications
Failure indication
lights up
"Water tap closed"
"Clean pump"
Description - Causes - Solutions
Appliance has no or insufficient water supply. The "Start(Pause)" light flashes.
Check whether:
• Water tap is fully open and water supply pressure is sufficient.
• Kinks are present in water inlet hose.
• Mesh filter of water supply hose is blocked (see "Care and Maintenance").
• Water hose is frozen up.
• Safety valve inspection window of your water supply hose is red (provided
your appliance has a water supply hose as shown on picture "A" - see
previous chapter "Care and Maintenance"); replace the hose by a new one
available through our After-Sales Service or your specialist dealer.
After problem has been removed, restart programme by pressing "Start
(Pause)". If the fault occurs again, contact our After-Sales Service (see next
chapter).
Waste water is not pumped out. The appliance stops in the corresponding
programme step; unplug it and check whether:
• Kinks are present in the drain hose.
• Filter or pump is blocked (see chapter "Cleaning the Filter/ Draining Residual
Water"; make sure the water has cooled before draining the
appliance).
• The drain hose is frozen up.
After problem has been removed, select and start "Drain" programme or push
"Reset" button for at least 3 seconds; afterwards restart desired programme.
If the fault occurs again, contact our After-Sales-Service (see next chapter).
GB 13