Intended Use; Safety Instructions - SATA SATAjet 1000 B Operating Instructions Manual

Operating Instructions SATAjet 1000 B (RP/HVLP)
[1-6] Air micrometer (air flow
control) locking screw
Air piston (not visible)
[1-7]
Compressed air connection
[1-8]
G ¼ „ (male thread)
[1-9] ColorCode-System (CCS)
[1-10] Paint spray gun handle
[1-11] Trigger
4.2. Air micrometer (aif flow control knob)
[3-5] Separate pressure gauge
with control device (see
chapter 13)
Separate pressure gauge
[3-6]
without control device (see
chapter 13)
5.

Intended Use

The spray gun has been designed for the application of paints, lacquers
and other sprayable media by means of compressed air on suitable sub-
strates and surfaces.
6.

Safety Instructions

6.1. General Safety Instructions
• Before using the spray gun, please read all safety and the operating
instructions carefully. Safety instructions and indicated safety meas-
ures are mandatory.
• Please keep all enclosed documents and make sure that the spray
gun is handed over only together with these documents.
Warning! Attention!
[1-12] Nozzle set consisting of air
cap, fluid tip (not visible),
paint needle (not visible)
[1-13] Paint spray gun connection
with QCC
[1-14] Gravity flow cup connection
with QCC
[1-15] Paint strainer (not visible)
[1-16] Gravity flow cup
[1-17] Gravity flow cup lid
[3-7] Pressure measurement in
compressed air circuit
SATA adam 2 (see
[3-8]
chapter 13)
EN
27