Troubleshooting - Smeg SW106 Manual

7 Troubleshooting

machine to factory settings. (See "Canceling the programme")
Water in the machine.
or distribute the load by hand to balance it homogenously in the machine.
anything.
Machine stopped shortly after the programme started.
voltage restores to the normal level.
takes in adequate amount of water. The machine will wait until there is sufficient amount of water
to avoid poor washing results due to lack of water. Timer indicator will resume countdown after
this.
reaches the selected temperature.
be activated due to the unbalanced distribution of the laundry in the drum.
C
Foam is overflowing from the detergent drawer.
main wash compartment of the detergent drawer.
C
Laundry remains wet at the end of the programme
C
A
dealer or the Authorized Service Agent. Never try to repair a nonfunctional product yourself.
Press and hold Start / Pause button for 3 seconds to reset the
This is not a failure; water is not harmful to the machine.
Mix 1 tablespoonful softener and ½ l water and pour into the
Adjust the feet to level the machine.
Remove the transportation safety bolts.
Add more laundry to the machine.
Take out some of the laundry from the machine
Make sure that the machine is not leaning on
Timer indicator will not countdown until the machine
Timer indicator will not countdown until the machine
Automatic unbalanced load detection system might
Use recommended amount of detergent.
17
EN
Clean the pump filter.
It will resume running when the