Appropriate Installation Location; Removing Packaging Reinforcement; Removing The Transportation Locks; Connecting Water Supply - Smeg SW106 Manual

Table of Contents

Advertisement

the product into its place after installation or
cleaning procedures.

Appropriate installation location

place it on a long pile rug or similar surfaces.
on top of each other reaches to approx.
180 kilograms. Place the product on a solid
and flat floor that has sufficient load carrying
capacity!
edges of other furniture.

Removing packaging reinforcement

packaging reinforcement. Remove the packaging

Removing the transportation locks

A
taking out the packaging reinforcement.
A
operating the washing machine, otherwise,
rotate freely (C).
them gently.
(P)
C
place to reuse when the washing machine
C
Never move the product without the
place!

Connecting water supply

C
water flowing from the fully open tap in one
minute to have your machine run smoothly.
Attach a pressure reducing valve if water
pressure is higher.
C
must install the supplied stopper to the hot
stopper group.)
C
product, connect the hot water hose after
removing the stopper and gasket group from
the hot water valve. (Applies for the products
A
Models with a single water inlet should not
a case the laundry will get damaged or the
product will switch to protection mode and will
not operate.
A
laundry.
1.
Connect the special hoses supplied with the
product to the water inlets on the product.
water inlet.
A
Ensure that the cold and hot water
connections are made correctly when
will come out hot at the end of the washing
process and wear out.
wrench when tightening the nuts.
hose connection to check for water leaks at
off the tap and remove the nut. Retighten
the nut carefully after checking the seal. To
prevent water leakages and damages caused
machine is not in use.

Connecting to the drain

connected to the wastewater drain or to the
A
out of its housing during water discharge.
Moreover, there is risk of scalding due to
high washing temperatures! To prevent such
situations and to ensure smooth water intake
and discharge of the machine, fix the end of
the discharge hose tightly so that it cannot
3
EN

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sw86

Table of Contents