Speed Selection - Smeg STA120 Instruction Manual

To switch on the machine and select programmes, proceed as follows:
1. Turn the programme knob in either direction. The machine switches on and the "Start" programme phase
LED lights up.
2. Select the washing temperature, within the sectors marked on the front panel by the following words:
•
Cottons, coloureds
•
Woollens
•
Synthetics, delicates
Attention!
•
The following partial washing programmes can be set using the programmes knob:
-Rinse with additive
-Drain and spin
-Fabric softener
These partial programmes are inside the Cotton, Synthetics and Wool sectors, except for the drain and spin
programme (Drain
•
If the indicated temperature shows 0°, this means that the programme performs a cold wash cycle. The same
cold wash is also performed by the Hand wash programme in the Wool sector.
•
The fabric treatment labels show which washing temperature must be set.
•
If various garments in the same load require different washing temperatures, choose the lowest wash-
ing temperature of all.
•
If the laundry is only slightly dirty and does not need the bleaching effect of high temperatures, a lower tem-
perature can be chosen to save power. In spite of the low temperature and consequent saving of electric-
ity, an automatic time control keeps the duration of the main washing unvaried compared with that of a high
temperature programme. It is therefore possible to successfully wash normally dirty laundry at lower wash-
ing temperatures than the maximum temperatures shown on the fabric care labels.

5.10 SPEED SELECTION

The models described in this instructions manual may either feature fixed or variable spin speeds. Models with
fixed spin speeds cannot be adjusted but can disable the spin cycle (
Other models are fitted with a button for selecting spin speed (see chapter 4 – Description of controls) which al-
lows one of three speed levels to be selected.
Press the button identified with the letter "H" in chapter 4 – Description of controls, the 3 LED's located over the
button light up in sequence to indicate (from top to bottom):
•
maximum spin speed
•
intermediate spin speed
•
final spin disabled and stop with tub full (
formed at the end of the washing programme and the machine stops with the tub full of water and the
washing soaked. To remove the soaked and dripping washing (drip-dry fabrics) turn the knob to "Drain
" and press the "Start/Pause" button. The water is automatically drained on all programmes without
spinning. If you wish to drain the water in the tub and then spin, turn the knob to "Drain
of the two available speeds (maximum or intermediate) with the select button and press the "Start-
Pause" button. These methods are also valid for fixed speed machines featuring the spin disable op-
tion.
With programmes in the Cottons/Coloureds sector, fabrics can be spun up to the maximum speed envisaged for
the model. For Synthetics/Delicates and Woollens, spin speed cannot exceed 900 rpm.
)
.
) if the model features this option.
): if this option is selected, the final spin is not per-
", select one
34