Smeg STA120 Instruction Manual page 8

A
Open door button
B
ON-OFF and washing pro-
gramme selection knob
C
Programme phase LED'S
Start
Wash
End
"Start/Pause" button
D
Press the button to open the door. Chapter 5 – Washing in-
structions – explains how the door works and how to use it.
This knob lets you:
•
switch the machine on and off by moving it in either
direction from the OFF position (knob indicator verti-
cal)
•
select washing temperatures within the various fab-
ric sectors by turning it in both directions
The knob does not move while the programme is running.
The programme is electronically controlled by the machine.
The programme phase LED's indicate which phase of the
programme the washing machine is in. The operating
phases, shown to the side of the LED's, are the following:
START
This LED indicates that the machine is on but the selected
washing programme has not started yet. This is the phase in
which the programme select knob has been turned but the
"Start/Pause" button has not been pressed yet.
WASH
The "Start/Pause" button has been pressed and the washing
programme is running. The LED remains on throughout the
washing programme.
END
The LED lights up when the washing programme has fin-
ished. It switches off when the machine is switched off (pro-
gramme select knob to OFF) or when the "Start/Pause" but-
ton is pressed again.
Press this button to start the selected washing programme.
During washing, press the "Start/Pause" button for about 3
seconds to pause the washing cycle. During the pause, the
"Wash" programme phase LED flashes.
To resume the washing cycle from where it left off, simply
press the "Start/Pause" button again.
28