Separately Sold Accessories - Godox DP400IIIV Instruction Manual

LCD Panel
Built-in Wireless Channel Dial
Built-in Wireless Channel
Built-in 2.4G Wireless
Transmission
Built-in Wireless
Group
Modeling
Lamp is off
Modeling Lamp is in
the PROP mode
Accessories
1. Power Cord
2. Lamp Cover
①
3. Instruction Manual

Separately sold accessories

The product can be used in combination with the following accessories sold separate-
ly, so as to achieve best photography effects: ①X1, ②X2, ③Xpro remote control, ④
Softbox, ⑤Photographic Umbrella, ⑥Light Stand, ⑦Honey comb, ⑧Beauty Dish ⑨
Snoot, etc.
①
TEST
SET
② ④
③
OPERATIONS
Flash Preparation
Attach the flash unit onto an appropriate light stand. Adjust the mounting bracket
for a good angle and make sure it is tightened and fixed. Use the direction adjusting
handle to adjust the flash to a desired direction. Umbrella input is for different
photo umbrellas to put in.
Receiver Model Indicator
Temperature
Alarm Display
Flash Output
Modeling Lamp is off
when triggering the flash
Modeling Lamp shows the
power in percentage
② ③
⑤ ⑥ ⑦ ⑧
11
Power Connection
Use the power cord to connect the flash to an AC power source and turn on the
power switch .
Beep
Modeling Lamp
Short press the Modeling Lamp Button to change among OFF, PROP and percent-
age mode.
1. When <OFF> is displayed, the modeling light is off.
2. When <PROP> is displayed, the modeling light is in auto status and its power
changes with the flash's power.
3. When percentage is displayed, the brightness of modeling light can be adjusted
from 5% to 100%.Short press the SET Dial and then turn it to adjust the brightness,
short press to exit.
When the modeling light is on, long press the Modeling Lamp Button for 2 seconds
to switch on the function that the modeling is off when triggering the flash, and the
LCD panel shows (
function.
Safety Setting：Modeling lamp will be off automatically after lighting for 4 hours,
avoiding overheat due to long-time lighting when the user is not nearby.
Power Output Control
SET dial decides different power output, satisfying light requirements in different
environment. The power is adjustable freely from 1/64 to 1/1 which will be accord-
ingly shown on the LCD display. "OFF" on the display indicates that the flash
triggering function is turned off. Press the test button to discharge power when the
flash output is adjusted from high to low.
Test Button
To fire the flash without taking a picture, press the test button. It can also help
adjust the flash brightness when combined with the SET dial.
⑨
Tip: Long press the SET dial and turn on the flash to view its version.
Sync Triggering
The sync cord jack is a Φ3.5mm plug. Insert a trigger
plug here and the flash will be fired synchronously
with the camera shutter. Synchronously press the
S1/S2 button and BUZZ button to recover factory
settings.
). Long press the Modeling Lamp Button again to turn off the
When there is flammable accessory on the flash unit, do not keep the
modeling lamp on for a long time. It is recommended to cool it down for
one minute after 10 minutes' working.
12