Advertisement
The inside of the machine comprises a moving assembly which is blocked for transport purposes by the screws
(
located at the rear of the washing machine.
1.
Release the assembly by removing these screws with a 13 mm wrench.
2.
Remove the screws (
3.
To prevent water from entering the machine or people from touching live components with their fingers,
Do not turn the machine upside down and do not place it on its side.
Keep all the components used to block the drum assembly as they will be needed if you decide to move the
appliance in future.
1.
Place the appliance in the
required position.
2.
Carefully level the machine
in all directions using a spirit
level
and
adjusting
height of the feet if neces-
sary. After adjusting the
machine, lock the feet with
the relative lock nuts.
The water inlet and drain hoses can be turned to the right or left depending on installation requirements.
Make sure the washing machine does not touch walls, furniture, etc., while it is working.
The appliance must not be installed behind a lockable door, or sliding door, or a door with hinge on the oppo-
site side to the tumble dryer
and relative spacers (
the
from the back of the washing machine.
Advertisement
