Table of Contents
Advertisement
| FOR
YOUR
REFERENCE
Troubleshooting
Please note that the appearance of any of the following phenomena does not indicate a méchanical failure of the
AVS-10.
Phenomenon
The ASV-10
is turned ON, but no
sound is produced from the Electone's
keyboard.
Cause and Solution
CD The MIDI cables, LINE cables, and/or the power adapter are not
properly connected. For example, the MIDI IN and OUT cables are
connected in reverse, the MIDI-1 and MIDI-2 cables were incorrectly
connected, etc. (™page 3)
@ The pertinent ENSEMBLE button is OFF. (page 6)
(S) The volume for the pertinent keyboard is set to "0". (page 7)
(4)The MIDI Receive Channel No. is set to receive the data sent from a
different keyboard than the one which you are playing. (page 16)
4—
AVS-10 is connected to a stereo, but
either no sound is produced from the
Stereo, or its volume is too small or too
loud, the sound is distorted, etc.
The
volume
balance
between
the
upper
and lower keyboards
differs
from the volume settings performed
at the AVS-10.
(DIE no sound is produced: The LINE cables are improperly connected.
For example, the LINE OUT (L) jack is connected to the AUX IN (R) jack,
the AUX IN jack of AVS-10 is connnected to the LINE OUT jack of the
stereo, etc. (page 3)
(2) If the volume is too small or too loud, the sound is distorted, ete.: Either
the LINE OUT selector switch is improperly set, or the connection to the
Electone's AUX IN or EXP IN jack is incorrect. (page 3)
The volume settings at the AVS-10 are being affected by the Manual
Balance setting at the Electone. The volume balance between the upper
and lower keyboards is designed to be set by the Electone's Manual
Balance function. If you want the volume balance to be solely controlled by
the AVS-10, set the Electone's Manual Balance function to the center level.
The Sustain effect is not produced.
The direction of panning does not
change.
The Reverb effect is not produced.
The functions do not operate properly.
ГА crackling sound is sometimes heard.
Interference from radio, TV, wireless
radios, etc.
Chart of the Display Indications
| The Sustain Length is set to "0". (page 9)
The Pan Position is set to "C" (Center). (page 10)
The Reverb Depth is set to "0". (page 11)
This may be caused by various reasons. Normal operation can sometimes
be restored by turning off the POWER switch, then SSES a Power-
ON Reset operation. (page 6)
Noise may be produced when either an electrical appliance is turned
ON/OFF or an electric power tool, such as a a neon sign or drill, is used
in the proximity of the AVS-10. In such case, plug the AVS-10 into an
electrical outlet located as far as possible from the device that seems to be
the source of the problem.
This is caused by the proximity of a high-power broadcasting station or
amateur ham radio station.
| Upper keyboard
LU
|
Regist. Bank
r
b
Lower keyboard
L
p J
Pedal keyboard
О
р
Transposition
E y
Pan Position
L Er
MIDI Receive Channels
U С; L C, D C
Reverb Depth
ro
MIDI Sleep Mode
5 L Ë p
Regist. No.
r
T
Transmission of Bulk data
5 Ë N
d
18
Advertisement
Table of Contents
