Setup At Local Site And Others; Function Selection Setup - Carrier 42TGF0131CP Service Manual

9-1. Function Selection Setup

<Procedure> Perform setting while the air conditioner stops.
1
TEST SET CL
Push + +
The first displayed unit No. is the master indoor unit address in the group control.
In this time, fan and louver of the selected indoor unit operate.
2
UNIT LOUVER
Every pushing
displayed one after the other. In this time, fan and louver of the selected indoor unit only operate.
3
Using the set temperature
4
Using the timer time
5
SET
Push button. (OK if indication lights)
• To change the selected indoor unit, proceed to Procedure
• To change item to be set up, proceed to Procedure
6
TEST
Pushing button returns the status to the normal stop status.

9. SETUP AT LOCAL SITE AND OTHERS

buttons simultaneously for 4 seconds or more.
button (button at left side), the indoor unit No. in the group control is
TEMP. buttons, specify the CODE No. (DN).
TIME buttons, select the set data.
TEMP.
3
TIMER SET
6
FILTER
RESET TEST SET
1
<Operation procedure>
1 2 3
2
.
3
.
ON / OFF
FAN MODE
TIME SAVE VENT
CL SWING/FIX UNIT LOUVER
4 5 6
END
- 54 -
4
5
2