Table of Contents
Advertisement
10 SOFTWARE UPDATE
Auto Update
When the Wireless Speaker is connected to the Internet, software
updates automatically occur even when the Wireless Speaker is
turned off.
• To use the Auto Update function, the Wireless Speaker must be
connected to the Internet.
The Wi-Fi connection to the Wireless Speaker will be terminated
if the Wireless Speaker's power cord is disconnected or the power
is cut off. If the power is cut off, when the power comes back on or
you reconnect the power cord, turn on the Wireless Speaker, and
then reconnect it to the Internet.
USB Update
Rear of the Wireless
Speaker
Samsung may offer updates for the Wireless Speaker's system
firmware in the future.
When an update is available, you can update the Wireless Speaker by
connecting the USB drive that contains the update firmware to the
SMARTTHINGS DONGLE port of the Wireless Speaker.
1. Go to (www.samsung.com) → search for the model name from the
customer support menu option.
• For more information about update, refer to Upgrade Guide.
2. Download the upgrade file (USB type).
3. Unzip the file to create a folder with the file name.
4. Store the created folder in a USB and then connect it to the
Wireless Speaker.
5. Turn on the Wireless Speaker. Then the product is updated within
3 minutes.
LED indicator :
‒ White moves from left to right and right to left
• During update, do not turn it off or remove the USB.
• If the yellow LED is on after the software update is completed,
this means that an additional update is in progress. When this
happens, don't turn off the power or remove the USB.
• If update does not proceed, reconnect the Wireless Speaker
power cord.
• When the latest version is installed, no update is performed.
• Depending on the USB type, update may not be supported.
SMARTTHINGS
DONGLE
ENG - 19
• If there is no update file available, the indicator blinks red
3 times.
LED indicator :
‒ Red Blinks X3
• If the update file is in the same or lower version than the
existing, the indicator blinks cyan 3 times.
LED indicator :
‒ Cyan Blinks X3
Reset
With the Wireless Speaker on, press the
the body at the same time for at least 5 seconds. The LED indicator
changes as shown below and then the Wireless Speaker is reset.
LED indicator
‒ White moves from left to right and
‒ Cyan Blinks X3
‒ Red Blinks X3
CAUTION
• All the settings of the Wireless Speaker are reset. Be sure to
perform this only when a reset is required.
Security updates information
Security updates are provided to strengthen the security of your
device and protect your personal information. For more information
on security updates, visit https://security.samsungtv.com.
• The website supports only some languages.
5 Sec
(Volume) buttons on
right to left
Advertisement
Table of Contents
