Table of Contents
Advertisement
09 INSTALLING THE WALL
MOUNT
Installation Precautions
• Install on a vertical wall only.
• Do not install in a place with high temperature or humidity.
• Verify whether the wall is strong enough to support the product's
weight. If not, reinforce the wall or choose another installation
point.
• Connect cables from the unit to external devices before you install
the Wireless Speaker on the wall.
• Make sure the unit is turned off and unplugged before you install
it. Otherwise, it may cause an electric shock.
• Make sure you use the wall-mount component parts provided with
this product. Under any circumstances, any accident resulting from
using third-party parts shall not be covered by the warranty.
Wallmount Components
(A) Wall Mount Guide (AH81-17401A)
x 1
(B) Bracket-Wall Mount
(AH61-04298A)
x 2
(D) Screw Anchor
(BN61-17904A)
x 4
(F) Spacer
(AH81-17402A)
x 2
(M5 X L55)
(C) Screw
(6011-008215)
x 1
(E) Holder-Screw
(AH61-03164A)
ENG - 17
1. Place the Wall Mount Guide against the wall surface.
• The Wall Mount Guide must be level.
• If you are mounting a device below a mounted object, install at
least 4inches (10cm) apart.
2. Use a pen to mark the positions of the holes and remove the Wall
Mount Guide.
3. Using an appropriately sized drill bit, drill a hole in the wall at each
marking.
• If the markings do not correspond to the positions of studs,
make sure you insert appropriate anchors or mollies into the
holes before you insert the support screws. If you use anchors
or mollies, make sure the holes you drill are large enough for
the anchors or mollies you use.
4. Push a screw (not supplied) through each Screw, and then screw
each screw firmly into a support screw hole.
(B)
4 inches (10 cm) or more
(C)
Advertisement
Table of Contents
