Installing The Cabled Psu - Dell CGJH2 Installation And Service Manual

Next steps
1. Replace the cabled PSU.

Installing the cabled PSU

Prerequisites
1. Follow the safety guidelines listed in
2. Unpack the replacement PSU.
Steps
1. Slide the PSU into the PSU cage and align with screw hole on the PSU cage.
2. Using the Phillips 2 screwdriver, tighten the screw that secures the PSU into PSU cage.
Figure 83. Installing the cabled PSU
3. Tilt at an angle and insert the PSU cage into the slots on the system then slide it towards the rear of the system until the
PSU cage is fully seated.
4. Using the Phillips 2 screwdriver, tighten the screws that secure the PSU cage into the system.
Safety instructions.
Installing and removing system components 93